How do I clean a rust stain from Angora fabric?

Start by vacuuming the area of the fabric that has a rust stain. Then mix two tablespoons of oxalic acid crystals into a cup of warm water. Dip an old toothbrush into the solution and, using a gentle motion, scrub the area of the fabric with the stain. Let the solution sit for 10 to 15 minutes before rinsing with cold water. Fill a sink or basin with cold water and add some mild laundry detergent. Place the stained fabric into the water and let it soak for approximately 30 minutes. Then, hang it up to air dry. Repeat these steps if necessary until the stain is completely removed.

WikiLaundry > Stains > Rust > Angora

Say Goodbye to Rust Stains on Angora with These Simple Tips

Rust stains can be a major eyesore on the delicate Angora fabric. Getting rid of them can seem like a daunting task, but it doesn’t have to be. With a few simple steps, you can make your Angora fabric look as good as new.

Updated 28 Jun 2023

By Jacobim Mugabe

When removing rust stains from Angora fabrics, it’s important to remember that the delicate nature of the material requires special treatment. These steps should help you clean your Angora fabric without causing any more damage.

Step 1: Vacuum and Pre-Clean

To start, vacuum the area of the fabric that has a rust stain. This will help to loosen any particles that are stuck in fabric. Afterwards, dampen the affected area with cold water and use a soft cloth or scrub brush to pre-clean the stain. Be careful not to rub too hard, as this can cause further damage to the fabric.

Step 2: Apply an Oxalic Acid Solution

Mix two tablespoons of oxalic acid crystals into a cup of warm water. Then, dip an old toothbrush into the solution and, using a gentle motion, scrub area of the fabric with the stain. After scrubbing, allow the solution to sit for 10 to 15 minutes before rinsing with cold water.

Step 3: Soak and Rinse

Fill a sink or basin with cold water and add some mild laundry detergent. Place the stained fabric into the water and let it soak for approximately 30 minutes. Once it’s done soaking, rinse fabric with cold water.

Step 4: Dry and Ready to Use

Once you’ve finished rinsing the Angora fabric, hang it up to air dry. Repeat these steps if necessary until the stain is completely removed.

Conclusion

Cleaning rust stains from Angora fabrics doesn’t have to be difficult. With a few simple steps, you can have your fabric looking fresh and free of rust stains.

Try Laundryheap - 24h laundry service with free delivery

Never do laundry again. Save time for things you ❤️

Book now

WikiLaundry